Memtech SC35 Betriebsanweisung

SC35 Mastodon 3.5” Solid State SCSI Drive User Guide 153205-001 Revision 4.8 July 30, 2002 Memtech SSD Corporation 7628 Las Positas Road Liv

SC35 User Guide Ver 4.8 August 30, 2002 Page 10 of 25 3.3.4 Format Unit Command – 04h The FORMAT UNIT command formats the medium into initiator a

SC35 User Guide Ver 4.8 August 30, 2002 Page 11 of 25 3.3.5 Read (6) Command – 08h The READ (6) command requests that the SC35 transfer data to t

SC35 User Guide Ver 4.8 August 30, 2002 Page 12 of 25 3.3.7 Inquiry Command – 12h The INQUIRY command requests that information regarding paramet

SC35 User Guide Ver 4.8 August 30, 2002 Page 13 of 25 Standard Inquiry Data Format Please refer to the SCSI specification for further details on

SC35 User Guide Ver 4.8 August 30, 2002 Page 14 of 25 3.3.8 Reserve Unit – 16h The RESERVE command is used to reserve a logical unit or, if the e

SC35 User Guide Ver 4.8 August 30, 2002 Page 15 of 25 3.3.10 Mode Sense The MODE SENSE (6) command provides a means for a target to report parame

SC35 User Guide Ver 4.8 August 30, 2002 Page 16 of 25 3.3.12 Read Capacity – 25h The READ CAPACITY command provides a means for the initiator to

SC35 User Guide Ver 4.8 August 30, 2002 Page 17 of 25 3.3.14 Extended Write (10) The WRITE (10) command requests that the SC35 write the data tra

SC35 User Guide Ver 4.8 August 30, 2002 Page 18 of 25 3.3.15 Erase Command Erase CDB The ERASE (10) command requests that the target erase the

SC35 User Guide Ver 4.8 August 30, 2002 Page 19 of 25 4. GENERAL SPECIFICATIONS Interface SCSI Compatibility ANSI X3.131-1994 SCSI Device Type 0

SC35 User Guide Ver 4.8 August 30, 2002 Page 2 of 25 Table Of Contents 1. HIGHLIGHTS 3 2. INTRODUCTION 3 3. GENERAL DESCRIPTION 4 3.1 SCSI

SC35 User Guide Ver 4.8 August 30, 2002 Page 20 of 25 5. INSTALLATION 5.1 Default Configuration The default jumper switch configuration is given

SC35 User Guide Ver 4.8 August 30, 2002 Page 21 of 25 5.2.8 Make sure that pin one on the cable, on the SCSI controller and on the SC35 are corre

SC35 User Guide Ver 4.8 August 30, 2002 Page 22 of 25 6. JUMPER CONFIGURATION 6.1 Switch Locations The following diagram shows the unit as viewe

SC35 User Guide Ver 4.8 August 30, 2002 Page 23 of 25 6.2 SCSI ID Selection 6.2.1 The SC35 can use any of the 8 SCSI IDs available on the SCSI bu

SC35 User Guide Ver 4.8 August 30, 2002 Page 24 of 25 7. TROUBLE SHOOTING GUIDE The following is a list of possible error indicators or messages,

SC35 User Guide Ver 4.8 August 30, 2002 Page 25 of 25 8. Appendix 8.1 Contact Information For Technical Support or Warranty Repair information, p

SC35 User Guide Ver 4.8 August 30, 2002 Page 3 of 25 1. HIGHLIGHTS • 27648 Mbyte uncompressed capacity • Full -40oC to +85oC operating temp rang

SC35 User Guide Ver 4.8 August 30, 2002 Page 4 of 25 3. GENERAL DESCRIPTION 3.1 SCSI Interface An intelligent SCSI controller from NCR, the 53C90

SC35 User Guide Ver 4.8 August 30, 2002 Page 5 of 25 3.2 SCSI Connector The SC35 uses a 50-pin right angle 0.1 inch center connector mounted on th

SC35 User Guide Ver 4.8 August 30, 2002 Page 6 of 25 3.2.2 SCSi Connector Pinout The following shows the pin connections for the SCSI connector u

SC35 User Guide Ver 4.8 August 30, 2002 Page 7 of 25 appropriate medium-access command without returning CHECK CONDITION status, this command shall

SC35 User Guide Ver 4.8 August 30, 2002 Page 8 of 25 3.3.3 Request Sense Command – 03h Request Sense CDB The REQUEST SENSE command requests tha

SC35 User Guide Ver 4.8 August 30, 2002 Page 9 of 25 Sense data format