Memtech AT3515 Betriebsanweisung

AT3515 3.5” Bulldog 3.5” IDE Solid State Flash Drive User Guide 80-03-00037 Revision 1.1 April 2006 Memtech SSD Corporation 2107 N. Firs

3.5” Bulldog User Guide April 10, 2006 page 10 of 13 4.2 MTBF The MTBF can be logically calculated in hours using the following formula. # Flas

3.5” Bulldog User Guide April 10, 2006 page 11 of 13 4.3.3 POWER ROUTING Bad power can lead to bad data. To avoid “glitches” or noise on the Vcc

3.5” Bulldog User Guide April 10, 2006 page 12 of 13 6. SPECIFICATIONS 6.1 INTERFACE IDE Compatibility ATA-3 compliant IDE Drive Number Driv

3.5” Bulldog User Guide April 10, 2006 page 13 of 13 7. APPENDIX 7.1 CONTACT INFORMATION For Technical Support or Warranty Repair information, ple

3.5” Bulldog User Guide April 10, 2006 page 2 of 13 Table of Contents 1. HIGHLIGHTS ...

3.5” Bulldog User Guide April 10, 2006 page 3 of 13 1. HIGHLIGHTS • 128 Mbyte to 8 Gbyte uncompressed capacity • Full -40oC to +85oC operating te

3.5” Bulldog User Guide April 10, 2006 page 4 of 13 3. INSTALLATION 3.1 PROCEDURE 3.1.1 ESD PRECAUTIONS Static electricity kills... electronics!

3.5” Bulldog User Guide April 10, 2006 page 5 of 13 3.1.4 MOUNTING The AT3515 may be mounted in any orientation. A total of four bottom and six s

3.5” Bulldog User Guide April 10, 2006 page 6 of 13 Drive Type Physical Capacity Cylinders Heads Sectors Available Capacity AT3515-128 128 M

3.5” Bulldog User Guide April 10, 2006 page 7 of 13 3.2.1 MASTER The drive is configured as a master device if no jumper is installed or if the

3.5” Bulldog User Guide April 10, 2006 page 8 of 13 3.2.4 WRITE PROTECT The Write Protect jumper prevents data from being written to the drive

3.5” Bulldog User Guide April 10, 2006 page 9 of 13 3.3 IDE INTERFACE The AT3515 uses a unitized signal and power connector. Maximum cable length